Download Silverstone SST-MS05B storage enclosure
Transcript
MS05 manual This is a unique product, please read the following detailed installation guide we have prepared meticulously for you. 1.Prepare for installation (2.5" hard drive shown must be purchased separately) 2.Remove two screws located on the side with the I/O port 3.Pull and slide out the internal tray 4.Place SATA hard drive in the internal tray 5.Push the hard drive forward until it is connected to the SATA connector 6.Secure the hard drive by inserting and tightening four screws on bottom of the tray 7.Slide the assembled internal tray back into the MS05 enclosure. Take great care to ensure that no wires or cables are caught in between the enclosure and the tray 8.In eSATA mode, both eSATA and USB cables must be connected 9.In USB mode, only USB cable needs to be connected Step2 install the 3.5" docking bay 1.Take out the 3.5" drive bay cover 2.Place 3.5" docking bay into the chassis and fasten it with screws 3 3. Connect the SATA cable to motherboard 4 4. Connect the power cable to power supply Warranty Information NO:G11204150 May, 2007